1960-1965 IGNITION LOCK CYLINDERS WITH KEYS

Our Products > Interior > Dashboard > Locks

SKU: C3AZ-11582-A

This Ford Falcon part will fit all models of the 1960-1965 Ford Falcon & Mercury Comet. To replace the lock cylinder, insert the key and turn the cylinder to the accessory position. Insert the end of a paper clip into the small hole in the face of the cylinder. Continue turning the key counterclockwise while gently pulling on the key. The cylinder should come out after the key is turned approximately 1/8 turn past the accessory position. To install the new lock cylinder, index the cylinder so that the key is turned approximately 1/8 turn counterclockwise from the accessory position. The brass pin should line up with the dimple on the back of the face plate. You will probably have to insert the paper clip in the hole to turn the key. Insert the lock all the way into the switch and turn the key clockwise until the cylinder locks in place. If you have an original ignition switch in a 1960 Ford Falcon, we recommend changing both lock cylinder and switch at the same time. 1960 Ford Falcon is the only year so affected. If your original ignition switch is designed for a 2 groove cylinder it will need to be replaced. The reproduction cylinders have 3 humps and will not work with the original 2 grove switch.

Price: $8.75

Add to Wishlist

Engines
Hardware
- Locks
- Molding Clips
- Nuts
- Screws
- Window Regulators

Interior (cont.)
- Glove Box
- Headliners
- Heaters
- Insulation
- Keys
- Kick Panels
- Knobs
- Lens
- Mirrors
- Molding Clips
- Package Trays
- Pedal
- Radios

Shopping Cart

1960-1965 IGNITION LOCK CYLINDERS WITH KEYS